Particle-bubble attachment in mineral flotation
Date
1999
Authors
Ralston, J.
Fornasiero, D.
Dai, Z.
Editors
Advisors
Journal Title
Journal ISSN
Volume Title
Type:
Journal article
Citation
Journal of Colloid and Interface Science, 1999; 217(1):70-76
Statement of Responsibility
Conference Name
Abstract
Attachment efficiencies of rough, angular, methylated quartz particles with nitrogen bubbles are derived from experimental capture efficiency data in conjunction with a collision model termed the Generalized Sutherland Equation (GSE). The methylated quartz particles ranged in size from 7.5 to 70 μm equivalent diameter and had advancing contact angles between 33°and 74°. They heterocoagulated with nitrogen bubbles between 0.77 and 1.52 mm in diameter in 0, 0.01, or 0.1 mol dm<sup>-3</sup> KCl. The attachment efficiencies decreased with increasing particle size and bubble size, but increased with particle contact angle and KCl electrolyte concentration. These attachment efficiency data were then used to test the Dobby-Finch attachment model for potential flow conditions. The latter model was modified so that the conditions of approach of the particle toward the bubble surface are the same as those defined previously in the GSE collision model (Dai et al., 1998, J. Colloid Interface Sci. 197, 275). Satisfactory agreement was obtained between the experimental attachment efficiencies obtained in this study and those calculated with the Dobby-Finch model. In the attachment efficiency calculations, the induction time (t(ind)) varied with particle size (d(p)) according to the well-known equation, t(ind) = Ad(p)/(B). The parameter B, with a value of 0.6, was found to be independent of particle size, particle contact angle, bubble size, and KCl electrolyte concentration. Conversely, the value of the parameter A was dependent on the particle contact angle, especially for contact angles smaller than 50°, and on the bubble size but to a lesser extent on the electrolyte concentration. The value of A decreased with an increase in particle contact angle and an increase in bubble size. The values of the induction time obtained in this study are in a reasonable agreement with experimental and calculated induction times reported in the literature.
School/Discipline
Dissertation Note
Provenance
Description
Access Status
Rights
Copyright status unknown