Surface modification of commercial cellulose acetate membranes using surface-initiated polymerization of 2-hydroxyethyl methacrylate to improve membrane surface biofouling resistance
Date
2011
Authors
Worthley, C.H.
Constantopoulos, K.T.
Ginic-Markovic, M.
Pillar, R.J.
Matisons, J.G.
Clarke, S.
Editors
Advisors
Journal Title
Journal ISSN
Volume Title
Type:
Journal article
Citation
Journal of Membrane Science, 2011; 385-386(1):30-39
Statement of Responsibility
Conference Name
Abstract
To improve biofouling resistance, cellulose acetate (CA) reverse osmosis membranes were modified by reacting surface hydroxyl groups with an atom transfer radical polymerization (ATRP) initiator, 2- bromoisobutyryl bromide, followed by polymeric grafting of 2-hydroxyethyl methacrylate (pHEMA) using activators regenerated by electron transfer (ARGET) ATRP. Thermogravimetric analysis (TGA), atomic force microscopy (AFM) and water contact angle (WCA) measurements of pristine and modified membranes were performed to measure and compare the amount of polymer deposited, the surface morphology and the hydrophilicity of the surfaces, respectively. Roughness and hydrophilicity increased with graft density. The biofouling resistance of pHEMA-modified membranes immersed in seawater aquarium tanks was compared to pristine membranes and the effect of pHEMA coating on water flux and NaCl rejection was measured. Based on stirred-cell and aquaria experiments, pHEMA-modified membranes with low graft density showed just a 6% decrease in salt rejection and water flux relative to pristine CA membranes, and a 24% improvement in resistance to seawater microbial biofouling.
School/Discipline
Dissertation Note
Provenance
Description
Access Status
Rights
Copyright 2011 Elsevier