Surface chemical mechanisms of inadvertent recovery of chromite in UG2 ore flotation: residual layer identification using statistical ToF-SIMS analysis
Date
2010
Authors
Jasieniak, M.
Smart, R.S.C.
Editors
Advisors
Journal Title
Journal ISSN
Volume Title
Type:
Journal article
Citation
International Journal of Mineral Processing, 2010; 94(1/2):72-82
Statement of Responsibility
Conference Name
Abstract
In the UG2 ore (Bushveld Complex, South Africa) flotation, normally more than 3% of the gangue minerals,principally chromite with talc and pyroxene, report to the concentrate diluting the PGM recovery and contributing to subsequent processing costs. Previous studies have identified residual talc-like layers onorthopyroxene surfaces in Merensky ore flotation contributing to inadvertent flotation of relatively large particles (20–150 µm) of this mineral. Chromite (75–150 µm) from flotation of UG2 ore has been similarly examined. Statistical comparison of ToF-SIMS analysis of particles from concentrate and tails reveals no significant difference in Cu, Pb, Ni and collector (IBX and DTP) signals between these streams but surface exposure of Mg and Si is favoured in the concentrate. The flotation rate of coarse chromite correlates with the exposures of magnesium and silicon in patches on the chromite surface; higher exposures give earlier flotation. Conversely, there is a negative correlation with signals corresponding to the chromite surface, i.e.Cr, Fe, Al. Flotation of chromite without collector has confirmed this statistical discrimination. Hydrophobictalc-like residual layers, similar to those found on orthopyroxene surfaces, probably from partial alteration,explain this flotation mechanism.
School/Discipline
Dissertation Note
Provenance
Description
Access Status
Rights
Copyright 2010 Elsevier