Simulation of the transmitted dose in an EPID using a Monte Carlo method
Date
2009
Authors
Pham, Thuc M.
Editors
Advisors
Bezak, Eva
Quach, Kim
Fog, Lotte
Quach, Kim
Fog, Lotte
Journal Title
Journal ISSN
Volume Title
Type:
Thesis
Citation
Statement of Responsibility
Conference Name
Abstract
The BEAMnrc and DOSXYZnrc codes from EGSnrc Monte Carlo (MC) system are
considered to be the gold standards for simulating radiotherapy linear accelerators and
resulting dose depositions (Rogers, Faddegon et al. 1995). The aim of this project was
to setup the EGSnrc system for the simulation of the linear accelerator (linac) head
and a Scanning Liquid Ionisation Chamber (SLIC) Electronic Portal Imaging Device
(EPID) for calculations of transmitted dose in the EPID.
The project was divided into two parts. The head of a 6 MV Varian 600C/D photon
linac was first simulated by BEAMnrc. The modelling parameters such as the electron
beam energy and the Full Width at Half Maximum (FWHM) of the electron spatial
distribution were adjusted until the absorbed dose profiles and the Percentage Depth
Dose (PDD) curves, in general agreed better than the measured profiles and PDDs by
2%. The X-ray beam obtained from the modelled linac head was used for the
simulation of the transmitted dose in the EPID in the second part of the project. The
EPID was simulated by DOSXYZnrc based on the information obtained from Spezi
and Lewis 2002 (Spezi and Lewis 2002), who also modelled the Varian SLIC EPID
(MK2 Portal Vision system, Varian Inc., Palo Alto, CA, USA). The comparisons
between the measured and the simulated transmitted doses were carried out for three
different phantom setups consisting of an open field, homogeneous water equivalent
phantom and a humanoid phantom (RANDO). These phantom setups were designed
so that the accuracy of the MC method for simulating absorbed dose in air,
homogeneous and inhomogeneous phantoms could be assessed. In addition, the
simulated transmitted dose in an EPID was also compared with values obtained from
the Pinnacle treatment planning system (v6.2b, Phillips Medical Systems).
In the process of selecting the electron beam energy and FWHM, it was confirmed
(Sheikh-Bagheri and Rogers 2002; Keall, Siebers et al. 2003) that the variation of the
electron beam FWHM and energy influenced the beam profiles strongly. The PDD
was influenced by the electron beam energy less strongly. The increase in the energy
led to the increase in the depth of maximum dose. However, the effect could not be
observed until the energy change of 0.2 MeV was made. Based on the analysis of the results, it was found that the combination of FWHM and energy of 1.3 mm and 5.7
MeV provided the best match between the measured and MC simulated beam profiles
and PDDs. It can be concluded that an accuracy of 1.5% can be achieved in the
simulation of the linac head using Monte Carlo method. In the comparison between
the Monte Carlo and the measured transmitted dose maps, agreements of 2% were
found for both the open field and homogeneous water equivalent phantom setups. The
same agreements were also found for the comparison between Monte Carlo and
Pinnacle transmitted dose maps for these setups. In the setup where the humanoid
phantom RANDO was introduced in between the radiation field and the EPID, a
general agreement of about 5% found for the comparison between Monte Carlo and
measured transmitted dose maps. Pinnacle and measured transmitted dose map was
also compared for this setup and the same agreement was found.
School/Discipline
School of Chemistry and Physics : Physics and Mathematical Physics
Dissertation Note
Thesis (M.Sc.) - University of Adelaide, School of Chemistry and Physics, 2009
Provenance
Description
This electronic version is made publicly available by the University of Adelaide in accordance with its open access policy for student theses. Copyright in this thesis remains with the author. This thesis may incorporate third party material which has been used by the author pursuant to Fair Dealing exceptions. If you are the owner of any included third party copyright material you wish to be removed from this electronic version, please complete the take down form located at: http://www.adelaide.edu.au/legals